I have created the custom sql, and created and added the parameter in dataset level itself. Custom SQL: SELECT date, count FROM xxx.yyyyyy WHERE date >= COALESCE(CAST(<<$StartDate>> AS TIMESTAMP) AT TIME ZONE ‘UTC’, ‘1900-01-01’::timestamp) AND date <= COALESCE(CAST(<<$EndDate>> AS TIMESTAMP)…

Hi Priyanka, If you are trying to select April 1 2025 as value in the end date control then that should give you the expected result. If that’s not the case. Can you provide additional information about with which control are we trying to attend this output and also parameter type info could also b…

Thank you for your support @Yamini_Baskar_24 I’m working with two date filters in Quick Sight: Start Date and End Date. By default, both filters display the full range of available dates (months, years, days), which is expected. However, I’m trying to implement the following logic: When a Start D…

Hi @priyanka1 Please refer the below community post this might be helpful for you. [image] Restrict Date Parameter value selection Question & Answer Hello @Vignesh_Kannan , if your parameter allows the user to enter any date for start and end period it is not possible to…

Hi @priyanka1 It’s been a while since we last heard from you. If you have any further questions, please let us know how we can assist you. If we don’t hear back within the next 3 business days, we’ll proceed with close/archive this topic. Thank you!

Hi @priyanka1 Since we have not heard back from you, I’ll go ahead and close/archive this topic. However, if you have any additional questions, feel free to create a new topic in the community and link this discussion for relevant information. Thank you!

Parameters - End date should always be greater than Start Date

Q&A

Xclipse August 9, 2025, 3:19pm 4

Hi @priyanka1

Please refer the below community post this might be helpful for you.

Topic		Replies	Views
Limit Date Ranges in a Parameter Q&A analysis , filters , quick-sight , Business-Intelligence-Engineer	3	54	December 10, 2024
Date filter with start date and end date in the table Q&A date , quick-sight , filters-controls-and-parameters	1	932	June 1, 2023
Restricting the selection on date range filter Q&A quick-sight , filters-controls-and-parameters , Business-Intelligence-Engineer	4	68	September 11, 2025
Date Filters not working as expected Q&A developer , error , quick-sight	4	71	August 1, 2025
Dynamic Start and End Date based on selections Q&A parameters , feature-request , quick-sight , Business-Intelligence-Engineer	5	70	April 21, 2025

Parameters - End date should always be greater than Start Date

Related topics