Filter Control holds last selected value

[Marim]

Hello Quicksight team,
I used filter control from Filter 1 to Filter 2
But if I change any values in Filter 1, The last value has still hold in Filter 2 but it should not need for me.
Please check the reference image, In my Filter 1 IDU has selected and in Filter 2 IDU05 has selected.
Then I need to change the value of Filter 1 into ODU as mentioned 1 in image ,then it should show only ODU01,ODU02,ODU03,ODU04 but it also showing the last held value IDU05 as mentioned 2 in image

Kindly support to resolve this issue.

[duncan]

Hello @Marim !

My assumption here is that you are using cascading filters. Unfortunately, even when you switch your parent filter, the second filter will hold that last value until you reset it.

To my knowledge this is still a feature request:

Cascading filter - selected filter value persists

I am creating a visual with two filters. I have created a cascaded filter wherein the 2nd filter’s value should refresh based on first filter’s selected value. However, it does not happen always. I have created the below analysis for reference on issue I am facing https://community.amazonquicksight.com#Arena-dashboardId=f2d55589-7ff4-45c6-a6c3-21fe56a469ec&authorId=CU-11778 To reproduce: I have 2 filters → ‘Pillar’ and ‘Audit’. Audit 1 - Audit 8 are applicable to Pillar1, Audit9 - Audit19 are…

I will mark this as a feature request as well.